The base frame is made of wooden beams. The two main beams on which the boiler is actually attached must be thick enough to support a weight of 120 kilograms. A hole is drilled at the top of these bars for the boiler mounting eyes.
The remaining supporting bars may be of a smaller cross-section, the main thing is that the structure is stable.
The bars are connected to each other using self-tapping screws, having previously drilled holes for their installation. They should be slightly smaller in diameter than the screws. To make the structure even more stable, a profile and additional tension plates are used.They are also secured with wood screws.
Since different boiler models have different sizes, design data is not given here. This needs to be done as you work. When the chair itself is ready, we place the boiler on it, opposite the holes in the main bars, and secure it with long bolts.
Where the boiler body comes into contact with the wooden base, you need to place pieces of rubber.
You can connect the boiler using flexible hoses that are one and a half meters long. This can be done both in the bathroom and in the kitchen.
It all depends on where it is more convenient. The boiler can be connected to the electrical network by connecting a cord with a plug.
It happens like this. that there is an outlet right next to it, if there is none, use a carrier.
It is clear that such a design takes up extra space, but you will always have hot water wherever you are.
