Way to lay a pipe under the foundation
The communication well was located at a distance of 1.2 m from the wall of the house. The width of the foundation is 0.4 m. It was decided to make the so-called. “puncture” under the foundation directly from the communication well. There are special tools and even machines for such work. I decided to make do on my own. A two-inch pipe was used as a working tool.Using a grinder, a cutting edge was created at the end of the pipe, which was supposed to facilitate the process of destroying the soil. I decided to create a hole in the ground in two stages. Therefore, two pipes with a length of 0.85 and 1.55 m were prepared. To achieve the minimum length of the hole, I drew a perpendicular to the wall of the house with chalk on the surface. I laid a wooden guide along it and hung a plumb line. Thus, by punching a hole along the guide, it was possible to maintain the desired direction. After completing the preparation, you could start working. The communication well was lined with brick. Using a hammer and chisel, a hole was made in the brickwork. I installed the prepared pipe into the hole and, rotating it, began to create a hole. The soil was packed inside the pipe. Periodically, I pulled the pipe out, rotating it, and freed it from the soil. The soil was clayey and quickly clogged the section. Therefore, to increase the depth of the stope, I additionally hammered the pipe 3-5 cm with a hammer. After about 30 minutes, the short pipe entered the entire length of the hole. I changed it to a long one. However, it turned out that the dimensions of the well were too small, and it was impossible to insert a long pipe into the hole. I had to dismantle the brickwork and remove a couple more bricks, and below the hole made, make a groove into which the pipe would go before it was inserted into the hole. Another hour and a half was spent drilling the remaining part of the hole under the foundation. The pipe was installed. You can lay a plastic pipe inside it. All that remains is to remove the floor and dig a trench along the foundation inside the house.To avoid removing excess soil inside the house, you can use a hand auger. This method is much faster than digging a trench, does not disturb the surface and does not require significant time.How to bring water to a house without an excavator and a team of diggers - https://enn.washerhouse.com/5840-kak-podvesti-vodu-k-domu-bez-jekskavatora-i-komandy-zemlekopov.html