In order to make this simulator, the following materials were used - profile pipe: 40X40X2 approximately 6 meters, 50X50X3 5 meters, 20X20X2 3 meters; foam rubber, leather deputy and plywood 10 mm.
Approximate drawings of this simulator were found on the Internet and everything was ready for the robot to begin.
After you have purchased a profile pipe, you need to cut it into pieces to fit your body. To adjust the back of the bench, hooks with 4 mm thick metal bars were invented.
When the finished bench was welded, it was cleaned with a grinder and sandpaper for painting. The back and seat were cut out of plywood - the back was 90x25 cm, and the seat was 30x25. They were covered with 10 mm foam rubber and leather. deputy
The racks were made multifunctional: racks for squats, bench presses, and parallel bars were also made. In order for them to move apart, two pieces of profile pipe 50X50X3 were welded and a pipe 40X40X2 120 cm long entered into it.It was fixed with a 10 mm embedded bolt.
