For a bouquet of roses we will need the following materials:
- pink ribbon, 2.5 cm wide and 230 cm long.
-white ribbon, 2.5 cm wide and 154 cm long.
- green satin ribbon 150 cm long.
-glue gun.
- for decoration: some beads, fishing line, braid.
- flower stamens.
- lighter.
- large hair clip.
- needle and thread.
- scissors.
We begin work by cutting the tape. We take a pink ribbon and cut it into strips 7 cm long. For one flower you will need 11 strips, and there will be three pink roses, respectively, 33 strips in total.
We start with one rose. We take 11 strips and begin to make flower petals from them. Burn the edges with a lighter. In each strip, we bend the corners on both sides to the wrong side and secure with sewing needles.
Now we take a needle and thread, preferably in the color of the ribbon, and fasten it along the edge where the needles were bent.
Then we tighten the thread and secure the resulting petal.
We make 11 such blanks.
Then we will collect the bud with a glue gun. It consists of 3 petals.We twist the first piece into a tube and secure it. Now we glue it to the middle of the second petal along the entire height, pressing the edges.
And glue the third petal, covering the free edges of the second. The bud is ready.
The second row also consists of 3 petals. We glue these blanks slightly overlapping each other, placing them in a circle.
But in the third row there will be 5 petals, also overlapping each other in a spiral. The flower is ready.
And in the end you get three pink and two white roses.
Now you need to glue the backing to the flowers. They are green, which means we will cut them from green satin ribbon. Cut strips 6 cm long, 25 pieces. 5 pieces per rose.
We take a strip, fold it in half lengthwise, right side inward, and cut it out with scissors, scorching it, gluing the edges to each other, or cut it out with a soldering iron with a fine tip.
We turn these 5 petals right side up, getting a boat shape.
But on one side of the leaves we cut off the corners from 0.5 to 1 cm, and burn the smooth edge.
When the leaves are ready, turn the rose upside down and glue these blanks with the cut sides to the middle of the bottom of the rose.
The rose with green leaves is ready.
In the same way we glue the leaves to all 5 roses.
Now we need a base on which we will collect our bouquet. Cut out 2 circles with a diameter of 7 cm.
And for decoration we take 40 cm braid and any thin fishing line 60 cm long.
We glue the braid onto one circle, cover it with the second circle and secure it with a glue gun.
We cut the thin ribbon into three strips and fold each strip in half twice, securing with a needle.
Straighten, you get 2 curls.
Now we take the stamens and glue them between these two blanks.And on the fishing line we glue small beads with a gap from each other.
Let's now start assembling the bouquet. Glue a curl of beads between two white roses.
And then we attach them to the finished base, gluing them with a gun. We will place them slightly away from the middle, closer to the edge.
Now the roses are pink, we place them side by side on the base.
To decorate a bouquet, you need to secure stamens with curls between the roses.
All that remains is to attach a large hair clip to the base with roses.
Well, the hair decoration is ready.
Good luck to all.
