 | Do you like working with wood? Then this is especially for you! Today I will show you how you can assemble a model of an old car from plywood. So, let's begin. First you need to cut out the following blanks with a jigsaw: This is the foundation of the entire car. The left part is the front part. |
 | Here we will add a roof to give you a rough idea of the proportions. |
 | This is the left and right side of the car. |
 | These are wings. You also need two of them. |
 | Four wheels with locking caps. |
 | Side surfaces of the engine compartment. |
 | Rear of the car. The so-called back. Performed in a single copy. |
 | I don't know what to call this. Installed immediately behind the radiator trim. In general, you will see |
 | This is the panel between the passenger compartment and the engine compartment. All cuts must be made very carefully! |
  | This is the engine compartment cover - the hood. It is necessary to carefully bend the plate, as shown in the photo. |
 | And these are two headlights and a steering wheel. The steering wheel is slightly larger than the headlights. |
 | These are external decorative wings. Without them, the model will look unfinished. |
 | This is the radiator grille trim. To give a better look, you can apply a drawing. |
   | This is a set of seats, in order: the upper part of the front seat, the lower part of the front seat, and the rear seat. |
 | Marker headlights located on the partition between the passenger compartment and the engine compartment. |
  | These are the two parts needed to give the interior a good appearance. |
  | Let's start assembling the car. We take the base and attach the sides to it. After assembly we should have the following: |
  | We install the rear seat into the grooves in the side parts. |
  | We need this part to attach the front seats. |
  | We fasten the front seats. We fasten the flat part horizontally, and the convex part vertically. |
  | Next, we attach the steering wheel and put on the “steering ring” |
 | Next, insert the back wall into a special groove |
  | We insert the “dashboard” into its rightful place. |
  | Now let's put on the roof. You need to get into special holes. |
 | Next, we install a partition between the passenger compartment and the engine compartment. |
  | Next, install the side covers of the engine compartment. |
  | Next, fold the sandwich. And put it in the right place |
  | Next we install the hood. |
  | Next we attach the headlights and dimensions to the partition |
  | After that, put on the wheels and fix them. To fix it, you need to turn the plugs as shown in the photo. |
| Then we attach the outer wings. The car is assembled! | |
