Abbreviations: v.p. - aerial loop, st.b.n. - single crochet, dc. - double crochet, p.s. - half-column, s.s. - connecting post.
1. First you need to decide on the size of the case. We take two skeins of white and work in two threads. We collect a chain of air loops (in this case, 60 vp). Number of v.p. will depend on the thickness of the threads used and the density of your knitting. We close in a circle. We dial 1 v.p. for lifting.
1st row: 60 st.b.n., 1 st.s.
2-5 row: 3triv.p. for lifting, 60 st.s.n., 1 st.s.
6th row: three ch. for lifting, 3 st.s.n., 1 v.p., next 3 st.b.n. through the loop.
7 and the following rows: three ch. for lifting, 60 st.s.n., 1 st.s. We knit in the round until the cover is the size of your tablet. P.S. We connect the walls of the cover.
2. Now we knit the so-called “lid”.
1st row: three v.p.for lifting, 29-30 st.s.n., turn the product over.
2-4 row: three ch. for lifting, 29-30 st.b.n.
Next, we tie the pocket around the edges of the st.b.n.
3. To make your case unique, you can use for decoration: small napkins, various motifs from Irish knitting, satin ribbons, beads and shells.
In this case, an orange flower is used, knitted from iris threads (yellow color and orange melange), a button tied with red iris threads and a red satin ribbon.
In addition to these materials, you will need: hook No. 0.75, needle and thread.
First we tie the button with red thread. To do this, we dial 3-4 vp. and close the circle.
2nd row: three ch. for lifting and 15-17 st.s.n. The number of stitches depends on the density of your knitting.
3rd row: three vp, then alternate two dc. and two senior sciences in one loop.
4th row: three vp, then in a circle, dc. Let's close the circle.
Row 5: three vp, then alternate two dc. and two senior sciences with a common top.
Next, we tear off the thread, leaving an end 40-50 cm long. Thread a needle.
We pass the thread in a circle and tighten it.
Sew the button to the flower, and the flower to the cover. So that the threads are not visible from the wrong side, the flower must be sewn to the top threads of the fabric.
4. Decorate the case with a satin ribbon! We put it on as shown in the photo. Sew the ends together.
5. Iron the cover. The product is ready!
