Materials:
- Nylon tights
- Scissors
- Wire
- Beads
- Stack
- Threads
- Tape
Let's start:
To begin, we will make blanks for the flower; to do this, we cut off 25 centimeters of wire and wind it onto a stack, intertwining the ends with each other.
Cut out a piece of tights slightly larger than the blank. We place the wire ring on the tights and cover the workpiece with nylon.
We tie it with threads or wire quite tightly and trim the excess ends a little.
Using this principle, we make 4 more petals for one flower.
We make the middle from beads. To do this, cut the wire and string 4 beads, twist the wire and arrange the beads as shown in the photo.
We collect our flower, if necessary, bend the petals a little. We twist all the ends of the wire.
In principle, the flower is ready, all that remains is to decide what to do with it next. If you want to make a bouquet, you can wrap the wire with tape. If you want to make a brooch, then wrap the wire around a pin and cut off the excess wire at the end.