Do it yourself
Life hacks, master classes, useful tips, recipes.
home » Electronics » alternative energy » Free electricity for lighting

The idea of ​​obtaining free electricity is using the potential difference between the network zero and the ground.

A small disclaimer: this method of generating energy works 100 percent. This is not a hoax, some incomprehensible device that draws electricity from the ether, some kind of miracle device on magnets, etc.

We will use the voltage difference between the 220 V network zero and ground.

In simple terms, there are wires from the power plant to consumers - zero and three phases. Since the wires have their own resistance, therefore, there will be a voltage drop on them. This is the tension we will catch. This potential also creates a phase imbalance.

It is legal?

Yes, the power grid is not punished for this, since we will not use the phase. And in fact this is not theft.

Will electric meters take this energy into account?

It all depends on the type of electricity meter. There are meters with one shunt (with one measuring element) - the most common and two-shunt (with two measuring elements).One shunt I just don’t take into account zero - since their measuring shunt is located on the phase.

How much electricity can you get?

It all depends on the number of subscribers in the network and the power of all wiring. Usually it's somewhere between 3-10 volts. If you connect a step-up transformer, you can light an LED lamp. The voltage after the step-up transformer is about 100-220 V.

Scheme

Any transformer from a radio, tape recorder, etc. It is advisable to use a low voltage of 3-9 Volts on the secondary winding.

Please note that you use all manipulations at your own peril and risk.

Precautionary measures

Be sure to install a 5-10 ampere fuse or circuit breaker in the circuit between zero and the transformer. This is necessary so that the entire structure does not burn out if the phase with zero is suddenly changed. The probability of this event is, of course, negligible, but you need to be prepared for anything. Rather, there is a high probability that the zero will break - and this happens all the time. And the machine gun will definitely save you.

Even when working with zero, be sure to turn off the network. Well, even free light should not be left unattended.

come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
5+two=
Comments (12)
  1. feelloff
    #1 feelloff Guests October 31, 2017 07:34
    20
    Here's another video on the topic.
    [media=https://www.youtube.com/watch?v=bhXCC_qamlY]
  2. Dmitriy
    #2 Dmitriy Guests 26 December 2017 19:57
    12
    Alas, if the house is old, the difference between zero and ground can reach 120 volts!
    1. Vania
      #3 Vania Guests 26 October 2018 06:48
      6
      yeah
  3. Irakli
    #4 Irakli Guests 12 March 2018 21:53
    15
    the voltage between zero and ground is 14 volts. What power can you expect in this case?
    1. I
      #5 I Guests 6 April 2018 12:22
      7
      Install a solar panel.
  4. Max
    #6 Max Guests 20 April 2018 20:19
    0
    In general, it’s better to put a varistor or something like that after the fuse, because otherwise the trans will most likely burn out first, at least if a phase comes
  5. We
    #7 We Guests 24 May 2018 21:45
    4
    And if you turn on a 12 volt LED strip through diodes with condensers?
  6. VVG
    #8 VVG Guests May 29, 2018 11:32
    5
    Actually, manipulations are not used, but done. (In this case, if not a magician) :)
  7. Calle
    #9 Calle Guests August 7, 2018 00:23
    7
    This voltage is very unstable, so it is practically impossible to use it.
    1. Dryunya
      #10 Dryunya Guests 7 October 2018 17:34
      13
      You are not right. Stable enough for practical work, but not with 100% load, I've been using this for over 10 years. Now I’m building a new workshop in the village, where this device will be repeated again
  8. Victor K.
    #11 Victor K. Guests 27 October 2018 20:52
    7
    The idea is working. Just keep in mind that the voltage is constantly changing. Personally, I once tried using this method to heat water in winter for chickens. I placed a 220V electric lamp under a container of water. It was enough to heat the water.
  9. Guest Sergey
    #12 Guest Sergey Guests 9 January 2019 21:09
    2
    Only if the imbalance goes to zero, there will be far from 3-14 volts. Do you want to burn down the house because of a ghostly freebie?

What can you do with a remote control?

How to make a barbecue from a sink with your own hands

The simplest battery-powered electric train

How to connect PVC pipes without a connector

«Do it yourself - with your own hands» - a site of interesting homemade products made from scrap materials and items at home. Step-by-step master classes with photos and descriptions, technologies, life hacks - everything a real master or just a craftsman needs for needlework. Crafts of any complexity, a large selection of directions and ideas for creativity.

We recommend reading

Washing machine error codes