Earrings with fluffy fur

Different / Jewelry and costume jewelry 9 013 1

Most girls prefer jewelry made of precious metals, but they do not refuse jewelry made from natural materials - stone, leather, fur. Earrings with stone beads and fur look stylish with almost any outfit. The technology for their manufacture is simple. Not only young people can cope with it, making original ones for girls present, but also representatives of the fair sex.

The following tool will be useful for the job:

ruler;
awl;
comb;
pencil;
small pliers;
small pliers;
transparent glue “Moment-Crystal”;
knife-blade;
scissors.

The material used is:

dyed arctic fox fur with long hair;
2 holder bowls with a radius of 0.9 cm, a height of 1.6-2 cm;
4 holder bowls for beads with a radius of 0.3 cm and a height of 0.8 cm;
2 beads made of stone to match the color of fur with a radius of 0.7 cm;
shvemzy - 2;
pins - 4, 3.5-4 cm long;
fur threads

Progress.

1. Take a piece of fur and prepare it for work.

Comb the skin, find the softest, non-overdried part of the flesh, determine the direction of the pile. The hair on the skin in earrings should go from top to bottom.Mark 2 rectangles 1.5x4-5cm on the skin. Blanks for earrings are cut with a blade from the skin side. The fur on the cut on the opposite side is completely expanded. After cutting, the skin on the workpieces is scraped with a blade for evenness. The cuts are cleaned off with a blade.

2. The rectangles are glued on the skin side and tightly wound into rollers. The roller is wrapped with thread on top. The thread is coated with glue.

3. When the part dries, the roller is pierced vertically with an awl.

4. A pin is inserted into the hole on the fur side. A holder bowl with a radius of 0.9 cm is placed on its tip.

For soft filling (leather, fur, fabric, knitwear), it is better to use hard bowls.

5. The excess pin is cut off with the cutting side of the pliers.

The rest of the pin, 0.5 cm long, should come out of the bowl.

6. A ring with a connector is made at the tip of the chopped pin using round pliers.

7. The second half of the earrings. Place a cup-holder with a radius of 0.3 cm, a bead and another similar cup on the pin so that they clasp the bead.

For hard fillers (metal, stone), soft bowls that change shape due to their openwork are good.

8. Using the cutting side of the pliers, cut off the tip of the pin with a remainder of 0.5 cm.

9. Using round-nose pliers, bend the ring.

10. Using split rings, connect 2 parts with a bead and fur.

The result was a design with the first mobility. These earrings will fit better on the neck.

11. The stitching is attached to the structure using detachable rings.

They will give the earrings a second movement.

12. If the skin is sensitive to base metals, it is better to use silver stitches.

13. To strengthen the rings on the earrings, you can carefully tighten them.

14. Earrings with stone and fur are ready.