So, to make a two-tier flower bed we will need the following material:
- an unnecessary car tire for laying the lower tier (size to your taste - it’s better when it is almost proportional to the upper tier);
- a car disk (again, which is no longer useful for a passenger car);
- a metal pipe up to 1.5 meters long and up to 6 cm in diameter (the thicker the pipe, the stronger and more stable the base of the upper tier. But remember that too wide a pipe can significantly reduce the area in the lower flowerbed, so choose the optimal diameter);
- sledgehammer;
- bolts and nuts (2 pcs.);
- a metal plate with two holes, 5 cm long and up to 2 cm wide;
- oil paint of two colors (one shade for the flower beds, the second shade for the stand, i.e. the pipe);
- paint brush;
- solvent (if necessary).
Step-by-step manufacturing process
Step No. 1. We choose a place to install a flower bed on the site and immediately lay a rubber car tire.
Step #2.We take a metal pipe and a metal plate to weld them together (here you need to use welding) and then in two holes you need to fasten bolts and nuts to the disk, bottom view.
Step No. 3. Use a sledgehammer to drive the pipe with the disc into the middle of the tire. In order not to spoil the welding of parts, it is necessary to place a wooden plank in the middle of the disk.
Step No. 4. Clean the car tire and wheel from dust and dirt. We paint a two-tier flowerbed in two colors. Let the paint dry. We place a film at the base of the disk to prevent soil spillage. Then we fill it with soil and plant flowers.
Such an original flowerbed will not only save space, but will also make your site beautiful!
