Required materials and tools:
- Hot glue.
- Sharp scissors.
- Tweezers.
- Lighter.
- Bead.
- Scrunchy.
- Stamens for a flower.
- Purple ribbon 5 cm wide.
- Lilac ribbon 3.5 cm wide.
Preparation method:
Make 6 rectangles of lilac ribbon. The length of each section should be 5.5 cm. Treat the cuts with fire.
Bend the piece as shown in the photo.
Then bend it again, connecting the edges of the workpiece. This is what the back of the piece should look like.
Turn the future petal towards you and bring the edge of its base to the center.
Now bend both ends of the base back. You will get a very unusual and voluminous petal.
Solder the end of the petal.
Make the same petals from the remaining segments.
Cut the purple ribbon into rectangles 7 cm long. Treat the sections with a lighter.
Also prepare a square piece of this tape and a small piece to secure the elastic.
Make 6 purple petals exactly the same way you did the lilac ones.
Hot glue a row of large petals to the base of the flower.
Glue lilac ones between the purple petals.
Now glue the stamens as shown in the photo.
Make 6 squares from the lilac ribbon. Process the cuts.
Fold the square in half. The front side of the tape should be on the outside.
Then bend the workpiece again.
Bring the edges of the workpiece together.
The end of the future petal must be carefully cut off and processed.
Cut off the back of the petal too.
Straighten the petal and process the cut.
Here is a standard petal "kanzashi"You should succeed.
Make the same petals from the remaining squares.
Apply hot glue to the sides of the petals to create a small flower.
Glue it to the main product, and secure a bead in the center.
Glue a rubber band to the back of the flower and secure it with a piece of purple tape.
Now your stylish hair accessory is finally ready!
