For creativity you will need:
- purple satin ribbon 2.5 cm wide;
- lilac satin ribbon 4 cm wide;
- white satin ribbon 5 cm wide;
- burner, glass, ruler, tweezers;
- hot glue (gun with rods);
- a beautiful center with a rhinestone for a flower;
- white openwork for headband;
- mesh (tulle) for decoration, white, preferably medium density.
Let's get creative. First of all, cut a narrow ribbon into pieces 7 cm long, about 15 pieces. We make sharp petals for the frill of the flower. We bend the piece of tape in half lengthwise and cut the angle at 45 degrees. Next, we bend two symmetrical clips at the base on the right and left.
Using the resulting petals, we glue a circle of satin with a diameter of 4 cm (cut it out in advance and be sure to scorch it with a lighter). Glue the petals in three to four layers evenly and symmetrically. You will get such a lush base for the flower, as in the photo.
We form the petals of the main flower. To do this, cut the white tape into 5 by 5 cm squares, 9 pieces in total. We form a sharp petal from each blank. Fold the square diagonally and bend it again - we get a triangle.
We cut the lilac ribbon into 16 squares measuring 4 by 4 cm. From eight we form inserts for white petals. To do this, bend the workpiece diagonally and fold the corners towards the center of the base.
We bend the lilac blank in half and put it into the white triangle. Try to make the center of one layer coincide with the center of the other.
We solder the base under the ruler with a hot burner. Try to get one straight line. We sew eight petals with a simple thread into one flower.
From the remaining eight lilac blanks we make simple petals as above, only without the white layer. We glue each petal into the slots of the flower, as in the photo.
Glue the flower onto a fluffy base of purple petals. In the middle of the flower we select a beautiful rhinestone to match the color. This flower has the middle of a festive pin on it, it is very beautiful, convenient and easy to glue.
Pre-measure the desired size on the head, then solder the edges with a burner, holding it with a ruler. We turn the work over and glue the tulle with folds. The size of the grid rectangle is approximately 10 cm wide and 7 cm long. Squeeze out more glue on top and apply a white lace bandage, press lightly.
After 10 minutes the work will dry and you can decorate the child’s head. If the length of the net is not suitable for the baby, you can always adjust it, remove it from the head and cut it with scissors to the desired size. Try to round the corners on the grid.
