For a master class on making badges for witnesses we take:
- Rep ribbons 12 mm wide, white and light purple;
- Template of seven-pointed stars with diameters of 10, 10.5 and 11 cm (we find templates on the Internet);
- Die-cut openwork circles from mother-of-pearl cardboard in purple and white;
- Circles with the inscriptions “Honorary Witness” and “Honorary Witness”, the diameter of the circles is 5-5.5 cm;
- Burgundy pad for tinting;
- Two metal pins on a round backing;
- A piece of white felt;
- White small half beads;
- Glue "Focus";
- Scissors;
- Lighter;
- Glue stick or double-sided tape.
The templates and circles with inscriptions were printed and you can cut them out.
The medals will be placed in this way. From largest at the bottom to smallest at the top.
We tint the circles with inscriptions in a circle using a pad and glue them onto the cut out circles.
We sew the circles. Now we take the ribbons and star templates.
We start from the center, apply the tape, spread a little glue and wrap the tape around the corner of the star and again to the center. So we wrap the star along all edges.
We make each star with a different ribbon and a different color. Now carefully remove our ribbon stars from all three templates.
We get three stars like this, we make exactly the same three stars again. Don't forget to burn the edges of the ribbons with a lighter.
Now we start collecting medals. We start with the largest star, then the middle one and the small one up.
We spread the stars from the ribbons in the center with glue, thus gluing them into one star. Glue a circle with an inscription in the center. And on the back of the star we glue a felt circle.
And on the felt circle we glue metal pins on a round base.
We glue half beads around the circle of inscriptions and the medals are ready.
These stylish badges came out to match the color of the wedding. Thank you for your attention and see you)))