5 accessories to expand the functionality of a screwdriver and drilling machine

The problem of small workshops is the lack of sufficient space to store all the necessary tools. In this regard, you have to use only the basic set. To specifically solve this problem, special devices are used to expand the functionality of an existing tool, which makes it possible to completely or partially dispense with additional machines and other equipment.

Lathe attachment to drilling machine

This device is installed on the base of the drilling machine.

On its sole there is a quill and a vertical stop for the incisors.

A special tip is clamped in the machine chuck.

A piece of wood is placed and pressed between the quill and the tip. The result is a small vertical lathe.

Dust-free drilling attachment

This attachment is simply a godsend for those who do not have a construction vacuum cleaner and at the same time are forced to make a lot of holes in the walls.It is a hollow plastic box with a hole and a spring installed in it. A drill is inserted through the spring and the hole and placed against the drilling mark.

The rotation of the drill sets in motion a spring, which, together with a special impeller, sends dust and chips into the hopper of the device, preventing it from falling to the floor.

Rivet attachment for screwdriver

This attachment eliminates the need for an electric riveter. It is clamped into the chuck of a screwdriver or drill. When the chuck rotates clockwise, the nozzle tightens the shank of the aluminum rivet, and after breaking, pushes the fragment back out.

Angled bit holder

This is a universal bit holder that allows, in addition to normal operation, to transfer speed to the bit at an angle if necessary. Unlike classic adapters, it can be installed at different angles. This device allows you to use a screwdriver in hard-to-reach places that cannot be reached with a short bat.

Cutter for making wooden balls

This device allows you to drill round smooth wooden balls from a board using a drill or screwdriver. Using a cutter, you first need to drill on one side of the board, making a hemisphere, and then on the other side, aligning it with the through centering hole. As a result of two passes, a wooden bead is obtained.

Watch the video