What you will need:
- shovel;
- chainsaw;
- scrap;
- sledgehammer;
- any board with a cross section of 30-50 mm.
The process of removing a stump with wedges
To completely remove a stump, you need to dig around it to expose the thick lateral roots. Using a chainsaw, you need to saw through the visible main branches of the roots and cut the stump crosswise along, as long as the length of the bar allows.
If the snag is very large, then more longitudinal cuts should be made. It is necessary that approximately each segment in cross-section is the size of 1-2 palms. If the pieces turn out to be larger, then it will be more difficult to break them off from the stump. However, it all depends on what kind of wood you have to work with. For example, if it is maple, then you can cut large segments. If the tree has twisted fibers, then on the contrary, you should try to cut them smaller.
Then you need to make wedges from the board.
The wider the board, the better.It is advisable to initially prepare a lot of wedges, since they break.
When inserting wedges into the cuts in the stump, you need to drive them in with a sledgehammer.
As they dive, they will split the wood. The first wedges break very quickly, but when the stump starts to split, the rest will go better.
If you feel that any part of the stump has already completely broken off, you need to pull it out with a crowbar.
This will allow you to break off the thin roots underneath. If the chipped piece does not work, then you need to deal with the rest of the snag. Having removed everything around it, it will be possible to cut off the thick root going down on the remaining segment with blows from the side.
As you work, you can hit the split parts of the stump from the side with a sledgehammer to loosen them. It is not advisable to drive a crowbar into the cracks like a wedge, since it can be severely pinched, and then you will have to fiddle for a long time to pull it back out. If you drive in wooden wedges, then at any time in a difficult situation you can safely cut the segment in half with a chainsaw, without fear of catching the clamped metal with the chain.
After removing the stump, the remaining pit should be backfilled and compacted. If you simply scatter the earth without trampling it, then the soil will shrink in this place for several more years.
Removing new and old stumps differs in difficulty. If the trunk was recently cut down and the roots are still alive and are also producing shoots, then you just need to drill a wide hole in the stump from the end and pour saltpeter into it. The roots will quickly die and lose elasticity, which will facilitate further removal - https://enn.washerhouse.com/5615-kak-izbavitsja-ot-penka-bez-fizicheskih-usilij.html
