What you will need:
- pruner;
- plastic box;
- sand;
- Kornevin;
- candle;
- river sand;
- Lutrasil 60 g/m2.
The process of cutting roses
In the fall, you can cut branches of absolutely any thickness. They are cut into cuttings with 4-5 buds.
The lower cut is made oblique 1 cm before the first bud, the upper cut is straight 1 cm above the last one. In this way, the required number of cuttings without leaves is prepared.
The cuttings must be kept for 2 hours in a solution of the growth stimulator “Kornevin”. For a small package 10 g. just add 200 ml of water. Immediately you need to seal the top cut of the cuttings with candle wax.
The cuttings are planted in pre-dug prepared soil in a slightly shaded place. Grooves 10 cm deep are cut on it. You need 2 short beds, which can be covered with a plastic box. River sand is poured into the grooves.
The cuttings are placed in grooves at an angle of 45 degrees in increments of 5-7 cm.Their lower end is slightly deepened, then they are covered with soil. They need to be covered with a plastic box on top.
Later, when the temperature at night begins to approach zero, they should be sprinkled under the box with pine needles or dried flowers in a 20 cm layer.
On top everything is covered in 2 layers of spunbond or lutrasil with a density of 60 g/m2. You can simply use a box and 3-4 layers of covering material.
In the spring you will need to remove the needles and leave one layer of lutrasil to gradually harden the cuttings. As the buds awaken and take root, they are carefully pulled out and seated.
