To make this hairpin you need:
- scissors.
- automatic hairpin.
- satin ribbons in blue and white shades.
- silver rhinestones.
- glue gun.
- center for flowers made of rhinestones.
- tweezers.
Making a hairpin.
To make a hairpin, you will need blanks with sides 5x5 cm from ribbons in blue and white shades.
Now from these parts you need to make petals for the central flower and leaves. To do this, the white and blue squares should be given a triangular shape by folding each piece in half.
Next, you need to lay them one on top of the other, aligning their sides with the fold and placing the blue blank at the bottom.
Then, holding the double part, you need to turn the corner from one side to the middle, covering half of the white tape inside.
Then the action should be repeated on the second side, giving the part a square appearance with a diagonal fold strip.
The prepared square must be folded into a triangle again along its fold line.
All that remains is to straighten the edges of the petal, cutting off the crooked and uneven corners and singeing the resulting sections with the flame of a lighter.
It remains to make the depth of the part, leaving 0.7 cm and cutting off the excess tape.
The result is a detail like this for the central flower. A total of 10 of them will be required.
Now you need to prepare the leaves to decorate the flower. First you need to prepare the centers for the leaves. A square of white tape must be folded in half, making two folds.
Then the edge of the triangle needs to be clamped with tweezers and twisted into a tight tube.
The edges of the tube should be scorched with a flame to secure the twist. The result is a white tube-shaped center for the leaf. You will need 4 such parts.
All that remains is to create leaves from the blue ribbon. The square blank needs to be folded into a triangular piece, folding it in half twice.
A tube of white tape should be placed in the center of the resulting triangle.
The length of the leaf should be 2.3 cm, the excess should be cut off, and the resulting cut should be carefully scorched with fire.
The depth of the part is 0.6 cm, the rest of the leaf must be cut off, immediately treated with scorch.
The result is a blue leaf with a white center.
Only 4 of these parts need to be made. All that remains is to combine the leaves by connecting them in pairs and gluing one petal with a rounded top between them.
From the remaining 8 petals you need to create a flower by gluing them into a circle.
Now the leaves need to be attached to both sides of the flower, complementing the inflorescence with the finished center.
An automatic hairpin should be attached to the reverse part of the jewelry.
All that remains is to complement the flower and its leaves with rhinestones and sparkles.
The decoration is ready!
